Pella Designer Series Sliding Door with DGP Drive Kit Parts (Early 2000s model)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is the Pella Designer Series sliding door blinds drive kit plastic parts.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 249
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Public Domain
This is the Pella Designer Series sliding door blinds drive kit plastic parts. The plastic pieces broke in my door and Pella no longer makes the part. There are 3 parts here (and their mirror for opposite side blinds), the plastic case that is at the top of the drive system (the bottom and top) and the slider.
To repair the door, unclip the glass from the door itself, slide a box cutter behind the rod that holds the slider to remove the tape connection to the glass, and replace the plastic parts.
The other option to repair is to pry the bottom rubber belt holder off the bottom of the track, allowing the tension to be released on the top. This will allow replacement of the part. Once you've put the new top in, you can pull tension on the part on the bottom of the rail/track until it slides on.
I printed everything at 100% fill, PLA, with .08mm layers. Importantly, print the case and top at 45 degrees angle with supports however you think is best. With that, it seems very sturdy. I couldn't get PETG to work at a 45 degree print angle.