Road Bike Disc Brake Bleed Block - Shimano
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This bleed block is designed for road bike hydraulic disc brakes. It is essential for maintenance.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 54
- Wydruki
- 0
- Wyświetlenia
- 218
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
This bleed block is a precision tool designed for road bike hydraulic disc brakes. It is an essential accessory for routine maintenance, such as bleeding lines or replacing hydraulic fluid. It ensures that the pistons remain properly seated in their retracted position, preventing accidental over-extension and ensuring the correct oil volume within the system.
Updated on 2026.05.06: Added two reinforcing ribs on the sides to prevent slipping through the brake caliper, following a request from a service technician friend.
Key Features
Optimized Fit: Specifically designed for common road calipers (e.g., Shimano 105, Ultegra, and Dura-Ace).
Note: Compatibility with SRAM systems has not yet been tested.
Piston Protection: Maintains consistent spacing to prevent piston damage or misalignment during the bleed process.
Ergonomic Design: Features a tapered lead-in edge and a grip side for easy insertion and removal, even when wearing oily workshop gloves.
Recommended Print Settings
Material: PETG or ASA is highly recommended due to their superior chemical resistance against mineral oil and DOT fluid. While PLA is suitable for light use, it may degrade if exposed to brake fluids over time.
Infill: 40% – 60% (Use a Grid or Gyroid pattern for maximum compressive strength).
Walls/Perimeters: 4 – 6 perimeters to ensure the block does not compress under hydraulic pressure.
Layer Height: 0.15mm – 0.2mm for optimal dimensional accuracy.
Usage Instructions
Remove the wheel and the brake pads from the caliper.
Clean the interior of the caliper to ensure no grit interferes with the block.
Insert the bleed block fully into the caliper.
Secure the block using the standard pad retention bolt or pin.
Perform the bleed process according to the manufacturer's technical manual.
Wipe the block clean with isopropyl alcohol after use to remove any residual fluid.