Sliding robe door safety latch
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Secures doors from sliding open or being opened by toddlers.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 278
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bedroom
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a print-in-place built-in robe door lock. There is the locking mechanism that unfolds into a right angled blocker, and a base. The base allows the mechanism to be attached to the door with double sided tape. I printed this with PETG and glued together with Plumma's Type P clear PVC glue. You need to used supports for printing due to latching mechanism (over hangs). Also you need 3.2mm diameter pins approx 15mm long. These engage the locking slots. I used some concrete nails (exactly 3.2mm diameter) to make the pins (just use a Dremel to cut them to length). Still totally toddler proof, just make sure its attached high enough on the door so its out of reach.