1 / 2
Test bench parts - FRAME Series ELITE Motherboard Tray — zdjęcie 1
1 / 2

Test bench parts - FRAME Series ELITE Motherboard Tray

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Test bench for the FRAME Series ELITE Motherboard Tray

Ocena
5 / 5
Polubienia
11
Pobrania
56
Wydruki
1
Wyświetlenia
585
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution

Turn the FRAME Series ELITE Motherboard Tray into an open test bench with this set of 3D printed parts. Featuring a mount for a 120mm fan for rear board cooling, support for reverse motherboard connectors and a triple slot GPU mount bracket.

The PSU sits flat in the rear under the main tray, with support for SHIFT connector PSU's as well.

Hardware needed:

  • Orange: 3 x M3 nuts and flat screws for GPU mounting

  • Yellow: 2 x M4 nuts

  • Blue: 2 x M4x20mm countersunk bolts

  • Green: included thumbscrews

  • Red: any short UNC 6-32 bolt

The Elite Tray will come with 6 screws which are used for the cable tie down brackets - these screws should be reused for the 3D printed parts.

  • 2 is for the GPU mount (3 is circled in the picture above, but only two can be used at a time since the bracket can move down a notch to support GPU's mounted a slot further down on the motherboard)

  • 2 is for the PSU

  • 2 is for the legs

For the fan mount, please use any standard UNC 6-32 screws.

Tagi