1 / 2
Test bench parts - FRAME Series ELITE Motherboard Tray — image 1
1 / 2

Test bench parts - FRAME Series ELITE Motherboard Tray

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Test bench for the FRAME Series ELITE Motherboard Tray

Rating
5 / 5
Likes
11
Downloads
56
Makes
1
Views
585
Reviews
1

Updated at source:

Model information

Category
Computers
License
Creative Commons — Attribution

Turn the FRAME Series ELITE Motherboard Tray into an open test bench with this set of 3D printed parts. Featuring a mount for a 120mm fan for rear board cooling, support for reverse motherboard connectors and a triple slot GPU mount bracket.

The PSU sits flat in the rear under the main tray, with support for SHIFT connector PSU's as well.

Hardware needed:

  • Orange: 3 x M3 nuts and flat screws for GPU mounting

  • Yellow: 2 x M4 nuts

  • Blue: 2 x M4x20mm countersunk bolts

  • Green: included thumbscrews

  • Red: any short UNC 6-32 bolt

The Elite Tray will come with 6 screws which are used for the cable tie down brackets - these screws should be reused for the 3D printed parts.

  • 2 is for the GPU mount (3 is circled in the picture above, but only two can be used at a time since the bracket can move down a notch to support GPU's mounted a slot further down on the motherboard)

  • 2 is for the PSU

  • 2 is for the legs

For the fan mount, please use any standard UNC 6-32 screws.

Tags