1 / 3
XOL Beltclamps for 9mm GT3 with 5mm Spacing (Different Tolerances) — zdjęcie 1
1 / 3

XOL Beltclamps for 9mm GT3 with 5mm Spacing (Different Tolerances)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

belt clamps that hopefully better fit your DW-TAS CNC carriage and the SIBOOR AWD CNC kit

Ocena
0 / 5
Polubienia
0
Pobrania
2
Wydruki
0
Wyświetlenia
39
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Partially due to the hardware I have on hand, maybe partially due to my printers accuracy, I had a really hard time fitting the pins of the carriage. It turns out that the whole belt/clip/tube assembly stuck out ~0.6mm from the back of the carriage, offsetting the tube too far to the back to easily fit the pin. When eventually properly seating the pin, one of the belts partially pulled out during belt tightening.

Oh and the smallest zip ties I had on hand are a little wider than the channel of the original model.

  • cable tie channel width increased from 2mm to 2.5mm

  • belt/clip/tube assembly radius increased from 7mm to 7.5mm

  • double-belt passthrough channel height decreased from 2.59mm to 2.5mm 

Tagi