Ultra-Slim Prusament Spool Extension Coupler Ring
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
For the new Prusament spools with twist-locking sides!
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 190
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
Need to re-spool that messy 2kg spool but don't have another empty 2kg spool? Want to make your own continuous 4kg spool? Perhaps you just want to extend the capabilities of an existing spool-repurposing project. This carefully tuned coupler ring firmly attaches two or more NEW Prusament hubs end-to-end with a satisfying click!
Even with only 4g of PETG filament, it is impressively strong!
Print:
Use PETG or other stiff filament. Avoid PLA as it can warp over time.
0.15 to 0.2mm layers (Your typical 0.2mm BALANCED preset will do).
Increase your perimeters to 5. This will ensure a solid and strong print.
No support!
Assemble:
If you haven't taken apart a spool yet, you can use an official Prusament spool opener to take your spool apart. https://www.printables.com/model/1464628-prusament-spool-opener
Place the coupler on one spool hub. Make sure all six bayonets are aligned.
Twist clockwise about 1/6th of a turn until you feel a *click*
Line up the next spool with the exposed bayonets and again twist firmly until you feel a *click*
What about the unused Prusament sides?
To completely use the other parts of your Prusament spool, check out my pegboard system that uses the sides of the spool for a satisfying and portable multipurpose pegboard!
Need a more rugged coupler? Check out whats included with my weather-tight lid system for the prusament hubs!