Bushnell Edge Tripod Mount/Case (1/4-20 Thread) V2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Public Domain
This is a "case" for a Bushnell Edge Rangefinder with a captured nut designed to enable mounting to a tripod or other accessory.
Update:
The shell was updated to a one piece design with enough flex to be installed onto the rangefinder.
Notes:
Model was printed in PLA with 15% infill.
Requires:
- 3d printed part (BUSHNELL RANGEFINDER MOUNT_V2)
- 2x 3mmx3mm heat set inserts
-2x 3mm x 7mm machine screws
-1x 1/4-20 thread hex nut
Assembly:
Install heat press inserts in the exterior holes on the right hand side of the shell as viewed from the back.
Install the shell on the rangefinder by flexing open the bottom of the shell. it should be a snug fit.
Place 1/4" nut in one side of the slot on the bottom of the shell.
Install machine screws in bottom portion of case (do not over tighten).