Drive Gear for Skil Model 594 Belt Sander
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The OEM gear broke apart. I used FreeCAD and an Addon to model a new gear.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 68
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Public Domain
The drive gear on my 65 year old Skil brand Belt Sander broke apart. The gear appears to be made of nylon that was (injection?) molded onto the drive shaft of the motor. I took dimensions from the broken parts as best that I could.
The belt pitch is 5 mm. The gear has 14 teeth. I used freecad.gears workbench to create a new gear. (sprocket.) I guessed that the tooth angle was 15 degrees. The metal shaft from the motor has a hexagonal fitting on it that bulges out in the middle, apparently to mold - and grab - into the gear. There was no way to duplicate that. (I suppose that I could have printed two halves of an insert for the shaft that matched the bulge, then placed the insert halves on the shaft and slid the gear over the inserts.) So I used a little bit of industrial adhesive on the shaft when I slid my printed gear on.
I printed the new gear using PCTG with all walls. (Set your perimeters for 20.) I've run the Sander without load and it spins fine. But I haven't sanded anything with it yet. So I don't know if the new gear will endure.