Case for Samsung S21 Ultra
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a case made to fit the Samsung S21 Ultra. It fits nice and snug with good protection of the screen and cameras.
- Ocena
- 3,333 / 5
- Polubienia
- 44
- Pobrania
- 800
- Wydruki
- 2
- Wyświetlenia
- 5333
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial
Note: The model does not include the “MR” logo shown in the picture. The uploaded model is just a flat back.
This case fits the S21 Ultra perfectly (at least with a flexible material--I printed with 95A TPU). It extends above the screen and also below the camera sensor group each about 0.5-1mm to prevent scraping. Everything fits very well and the buttons work great!
Test Prints
There's a couple of “tricky” sections of this print, especially if using a flex material. I've included STLs of them so that you can do some tests prior to the full print:
- TEST-Bottom Ports: This is a good test to make sure you can print the overhangs and that your phone will fit into the width of the print (the height is a little tough to judge with just this test).
- TEST-Side Wall: I struggled to print the chamfer of the outer case wall without my TPU blobbing out the side (this was my first TPU print). This is a good are to test to make sure you don't suffer the same thing. If you do blob out the side, I found that slowing down the print helped a lot.
Print Settings
Layer Height:
0.1-0.15. I had trouble with the overhangs on the bottom port cutouts with anything greater than 0.15.
Infill:
5-10%. With flex material, you probably don't want/need much more. The infill really only applies to the back of the phone case since the side walls are too thin.
Perimeters:
2-3
Support:
Not advised unless you have trouble printing the bottom port cutouts