EMS-ESP ESP32-S3 N16R8 case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
EMS-ESP ESP32-S3 N16R8 case
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 144
- Wydruki
- 0
- Wyświetlenia
- 790
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Case I designed as I couldn't find a case for my particular circuits available. My ESP32-S3 had soldered on PINs, so I created a raised bed for it next to the EMS interface board. I also included slits for fixing the boards in place with a ziptie, but the fit of the backstops should suffice and the case is like 5mm too wide for the ziptie to work anyways.
Included holes in the lid for LEDs and onboard buttons. Lid is snap fit.
Consider printing the case at 45° with a few drawn-on supports, that should give all standoffs and pegs sufficient strength.
(Pictured above is a rushed V1 print on crappy free filament, hence the gnarly artifacts.)