D.G. capsule Spool carousel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
D.G. capsule Spool stand
- Ocena
- 0 / 5
- Polubienia
- 92
- Pobrania
- 73
- Wydruki
- 0
- Wyświetlenia
- 1124
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
D.G. capsule Spool stand
I have been thinking for a long time about a meaningful use of an empty Prusament spool. I had a similar model on a capsule before, so I used certain elements from it. After many attempts, I finally hit the width of the ring on the capsule.
Failures
Too bad that the hexagonal holes on both sides of the spool are not symmetrically aligned. That's why I had to use clips at equal distances between the rings.
I didn't have an empty new spool, so I disassembled an almost full one - and in the end I had to manually!!! wind about 250m of filament onto an older type of Prusament spool - it took me about 15min, my hands!!
That convinced me that I wanted to make a filament winder for the spool.
I also discovered that on the spool I was using, the sides were expanding outwards a bit - About 1mm probably due to the pressure of the wound filament. That's why I spent a long time trying to find the size of the ring.
For smoother movement, I recommend cleaning the clips with a 5mm drill bit.
Loaded
Empty
Partlist
Spacer
Cleaning
