D.G. capsule Spool carousel
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
D.G. capsule Spool stand
- Rating
- 0 / 5
- Likes
- 92
- Downloads
- 73
- Makes
- 0
- Views
- 1,124
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
D.G. capsule Spool stand
I have been thinking for a long time about a meaningful use of an empty Prusament spool. I had a similar model on a capsule before, so I used certain elements from it. After many attempts, I finally hit the width of the ring on the capsule.
Failures
Too bad that the hexagonal holes on both sides of the spool are not symmetrically aligned. That's why I had to use clips at equal distances between the rings.
I didn't have an empty new spool, so I disassembled an almost full one - and in the end I had to manually!!! wind about 250m of filament onto an older type of Prusament spool - it took me about 15min, my hands!!
That convinced me that I wanted to make a filament winder for the spool.
I also discovered that on the spool I was using, the sides were expanding outwards a bit - About 1mm probably due to the pressure of the wound filament. That's why I spent a long time trying to find the size of the ring.
For smoother movement, I recommend cleaning the clips with a 5mm drill bit.
Loaded
Empty
Partlist
Spacer
Cleaning
