Foger Vape Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Case for Foger vape.
- Ocena
- 5 / 5
- Polubienia
- 25
- Pobrania
- 535
- Wydruki
- 3
- Wyświetlenia
- 1445
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
No more dropping your vape and having your battery break off and fly across the floor!
Print settings: layer height 0.28mm, no supports, 3 walls
The bridge on the top of the window is a bit long, so it might droop. I hit it with a torch for a second and press it up and you couldn't even tell.
Some filaments print stiffer than others. The vape slides in at an angle above the side window opening. Removing the vape requires you to remove the same way, sometimes slightly bending the corner open. Pulling it sideways and up by the mouth piece is the easiest way.
Printed on AnyCubic Kobra S1 and Kobra X. Modeled with OnShape.
Note the CC license does not allow for resale of model file or physically printed case.