Neat Bumblebee II Shock Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Shock mount for Neat Bumblebee II microphone that uses hair ties. Hangs upside down from scissor stand (Not included).
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 35
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Gross. Hard to assemble. Does not deserve to exist. But neither does e-waste! Since it's back up on Woot, I tried to make some changes that would save this crappy model just to get it published. This model is for such a particular use case and has so many problems that you'd be equally well off designing your own.
Model screenshots are accurate; photo is not. Photo was taken of the original design, and the model was adjusted slightly to maybe accommodate a larger hair tie or at least be less of a pain to assemble. No promises though. Originally modeled for "Fine Hair" size hair ties.
Warning: Good luck getting this thing off once it's on. Or on in the first place, for that matter. The mic is heavy and hangs upside down, so I wanted it to be a friction fit. Redesign addresses the LED ring clipping against the sleeve. Or maybe it doesn't! Only one way to find out...
PRINT IN PETG OR PCTG SO IT DOESN'T SNAP DURING FITTING
Credit to u/TheseShoulder4870 on Reddit for making the outer ring's profile. Original model is not located on a print sharing site. STL of the ring is included in the f3d file though, as well as a partially complete scan of the mic with enough detail to reasonably capture the mic's contour and certain approximate feature sizes.