Super fast silica gel desiccant spool container - vase mode
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Silica gel spool container, vase mode (less than 20 mins) compatible with cheap round chinese termometer/higrometer.
- Ocena
- 4,885 / 5
- Polubienia
- 812
- Pobrania
- 4611
- Wydruki
- 136
- Wyświetlenia
- 19 283
- Oceny
- 130
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
About
I really love original Silica gel spool container by @gdrag. However I wanted to achieve Three additional goals:
- Make a spiral (vase) print to reduce filament and time,
- Add some distance between side holes and internal wall of the spool to improve air circulation,
- Use cheap Chinese hygrometer/thermometer as a cap, so I can know more or less if I'm successful at drying filament.
How to print:
- adjust bottom thickness to 1mm
- use spiral (vase) mode (optional for cap)
- I tried 0.25mm layer height (but think everything between 0.1 and 0.3 will work)
- The print works fine for 0.4 - 0.7 line width - for thicker lines - hole diameter can be to small and you can have some problems closing container with cap or hygrometer. Make a single test print before bigger batch. You can always try “XY compensation” (remember to compensate only container - not the cap) in slicer - but I'm not sure if it works in vase mode. Nevertheless up to 0.8 works for me - it's just very tight.
Cura users:
New Cura (5.2) removes all bottom holes by default in spiral mode - so after enabling “Spiralize” you have to uncheck “Remove All Holes” option to reenable holes on the bottom of the container.
I used my Anycubic Mega (with changed printhead and Klipper firmware) and it prints in about 20 minutes (short version)
TODOs:
- (done) Make various heights
- (done) Make lightweight cap in case One doesn't want to use hygrometer
CHANGELOG:
13.07.2022.
Redesigned container:
- New project (but based on previous shape)
- Minor changes to help print better
- Two flavours:
- small_gap: holes on tom and bottom are narrower (1mm) and segments are 2mm thick
- big_gap: holes on tom and bottom are wider (1.4mm) and segments are 2.5mm thick
- Three sizes for each flavor (50mm, 70mm, 100mm)
12.04.2022.
Redesigned container:
- Added route for inserting hygrometer.
- Added curves to the design to reduce sharp corners and deceleration points. Now container can be printed below 15 minutes
- improved bottom grid pattern
Added cap, so even if You don't have hygrometer, You can still use this design
11.04.2022.
Initial design