Ryobi Wall Mount Infared Thermometer Holster
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A holster to hold my Ryobi infrared thermometer on the side of my 3D printing table. I designed it with the intent of…
- Ocena
- 5 / 5
- Polubienia
- 5
- Pobrania
- 26
- Wydruki
- 1
- Wyświetlenia
- 250
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
A holster to hold my Ryobi infrared thermometer on the side of my 3D printing table.
I designed it with the intent of M3 screw (nuts) to be able to sink into the plastic a few mm (about half the nut head).
Designed around the thermometer. Coincidentally it is just slightly larger than the 1.5" portion of a 2"x4" board
Very unlikely this would work for any other thermometer since this design uses existing grooves on the shell.
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK2S
Rafts:
Doesn't Matter
Supports:
Doesn't Matter
Resolution:
Any (Reccomend 0.20-0.35 mm layer heights)
Infill:
20% (0% would probably work)
Notes:
Very simple part to print. Just use large layer heights to save time. Not much infill, so might as well save a little material.
Category: Tools