1 / 4
Sony a6500 offset Vivo monitor mount
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I use an a6500 as my webcam, mounted to the top of the vertical tube (between my 2 monitors) on a Vivo desk mount
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 27
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
I needed an offset mount to set my Sony a6500 back on the top of the Vivo monitor tube, so the monitors could angle inward closer.
It's designed to be printed as it come into your slicer, with the recesses facing upward. No supports are required.
I used PLA, with 1.8mm walls, floor and ceiling and 20% gyroid infill. Plenty strong, nice tight fit for the 1/4" 20 bolt, but the hex head I had on hand was only 10mm, and the recess is 14mm