La Crosse Weather Station Shield Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a replacement mount for the solar radiation shield for the La Crosse weather station remote sensor probe
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 70
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a replacement mount for the solar radiation shield for the La Crosse weather station remote sensor probe enclosure model 925-1418. These units are the ultimate torture test for filament so at a minimum use PETG. ASA or ABS would be preferred. I included 4 screw holes like the original and also 2 slots for zip ties etc if you need. I did not curve the back side so if you need this to conform to a very curved post, you may need to slightly heat it. Just be sure not to deform the dovetail.
Print settings are (for PETG):
0.4mm noz
Layer height: 0.28
2 walls
25% infill (can try for less but i wanted to avoid temperature flexing)
No brim, no support.
Uses ~21 grams