La Crosse Weather Station Shield Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a replacement mount for the solar radiation shield for the La Crosse weather station remote sensor probe
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 6
- Makes
- 0
- Views
- 73
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial
This is a replacement mount for the solar radiation shield for the La Crosse weather station remote sensor probe enclosure model 925-1418. These units are the ultimate torture test for filament so at a minimum use PETG. ASA or ABS would be preferred. I included 4 screw holes like the original and also 2 slots for zip ties etc if you need. I did not curve the back side so if you need this to conform to a very curved post, you may need to slightly heat it. Just be sure not to deform the dovetail.
Print settings are (for PETG):
0.4mm noz
Layer height: 0.28
2 walls
25% infill (can try for less but i wanted to avoid temperature flexing)
No brim, no support.
Uses ~21 grams