Kanto Badges Case in two halves
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I split the badge case into two pieces
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 66
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props
- Licencja
- Creative Commons — Attribution — Noncommercial
I simply added some negative volumes to get rid of the top/bottom and saved them as separate files.
I added a solid cylinder through the hinges to fill the space, then inside of that cylinder I added a smaller negative volume that matched the diameter of the wire I used as the hinge. I had some spare copper wire I think from some Romex that worked perfectly. I pushed the wire all the way through, then backed it out a bit, cut it, then pushed it all the way in so it was recessed a tiny bit.
In the file, you can change the diameter of the smaller cylinder (the negative volume) to allow for different sized wires, or acrylic rods, or whatever you have. I had it set to 1.9mm for the copper wire.
Also including in the Files an adapter ring that lets you use 6x3mm magnets for the badges, because that's what I had on hand.