Kanto Badges Case in two halves
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I split the badge case into two pieces
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 7
- Makes
- 0
- Views
- 66
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Props
- License
- Creative Commons — Attribution — Noncommercial
I simply added some negative volumes to get rid of the top/bottom and saved them as separate files.
I added a solid cylinder through the hinges to fill the space, then inside of that cylinder I added a smaller negative volume that matched the diameter of the wire I used as the hinge. I had some spare copper wire I think from some Romex that worked perfectly. I pushed the wire all the way through, then backed it out a bit, cut it, then pushed it all the way in so it was recessed a tiny bit.
In the file, you can change the diameter of the smaller cylinder (the negative volume) to allow for different sized wires, or acrylic rods, or whatever you have. I had it set to 1.9mm for the copper wire.
Also including in the Files an adapter ring that lets you use 6x3mm magnets for the badges, because that's what I had on hand.