Mountain Bike Brake Spacer - SRAM Code
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Brake spacer specifically for SRAM code brakes but should work for most 4-piston MTB brakes
- Ocena
- 5 / 5
- Polubienia
- 7
- Pobrania
- 37
- Wydruki
- 1
- Wyświetlenia
- 171
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution
Brake spacer specifically for SRAM code brakes but should work for most 4-piston MTB brakes.
How to use:
Use this print for brake bleeds or general maintenance when you are worried you might accidentally squeeze the brake levers (rough day when this happens).
Remove front or rear tire
Remove snap clip from brake pad screw (don't lose this part... its quite small)
Loosen and remove screw
Remove brake pads
Install printed spacer from the top side of the brake calipers using the extended tab
Align the hole in the spacer with the screw holes in the caliper
(Optional) Install the screw to keep the spacer in place
THIS MODEL WILL NOT WORK WITH THE BRAKE PADS INSTALLED. (If you would like a spacer for times when the pads are installed then let me know in the comments.)
Printing:
Material: PETG (Other materials should work as well, I just prefer PETG for most everything I print)
Slicing: Extremely easy
Perimeters = 3
Infill = 30% Grid
Profile = Balanced
Supports = None (keep the thumb indention side up)