1 / 1
12mm Tactile Button Cap
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Open Community License v1
This is a really simple little key cap for the 12mm tactile buttons that often come in electronics kits. I intitially wanted to make square buttons but found that it's impossible to make them align due to the amount of slop in the button stem.
Note: print top down on your print bed, when you install them the gaps in the stem go over the corners of the stem, not straight up and down (not that it matters because they're round, but you'll have a hard time getting them on square).
They print fine on a 0.4mm nozzle at 0.15mm layer height.
I have also included just the stem part should you want to make your own keycaps.