Caddy², a Dell OptiPlex 3020 7020 9020 SFF 2.5" drive caddy... caddy.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A caddy that repurposes the optical drive slot on the DELL MZ60045 drive caddy to mount clip-in 2.5" drives.
- Ocena
- 5 / 5
- Polubienia
- 5
- Pobrania
- 46
- Wydruki
- 1
- Wyświetlenia
- 601
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
A caddy for your Dell DELL MZ60045 caddy: a caddy².
It fits 3020 7020 9020 SFF PCs, and possibly others.
This allows you to repurpose the optical drive slot on your Dell caddy, and mount a 2.5" SATA drive in its place.
Drives clip in and out easily, without having to remove the caddy itself, so this is ideal for an SSD+HDD setup, where you might need to swap the boot drive often.
Materials
PETG is strong and flexible enough for the clips, and you'll need a strong glue to hold the clips in place. I like UHU "all-purpose adhesive", YMMV.
Printing, plating
Clips should be printed flat side down, they'll break otherwise.
Assembly
If you have fit issues, comment or post a make and I'll update the model. I'll likely make a new iteration that looks... nicer. I had a hard time just making this fit, and I didn't spend time making it look and feel nice to use.
To clip a drive in, you'll need M3 x 4mm hex-head bolts - which is usually the shortest you can find.
Since not all drives have enough thread on the side mounting hole OR could vary in width by a few millimeters, there's a trick in assembly!
The clips can be glued in place in two ways, as you can see on the model (front vs back). The little nub that holds the caddy in place also needs a dab of glue, but this one's also a tighter fit.
One way allows you to mount a standard 71mm-ish wide drive with bolts fully screwed in.
In case this doesn't work for you for any reason (usually because the bolts don't go all the way in or when you can only find longer ones), you can reverse the clips to gain 2mm clearance on each side, and thread a 2mm tall hex nut on the bolt or use some washers.
The prints on the photos are a previous revision with extra clearance. Measure twice, glue once!