Tool Battery Charger Mount Templates
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Templates for mounting various power tool battery chargers with #8 cabinet screws.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 101
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Public Domain
These are not mounts. I did not trust that PLA would have strong enough layer adhesion to make proper mounts, so these are just templates for use with #8 cabinet screws. I used GRK screws, but most other brands should work.
The Kobalt mount is a bit of a tight fit on the cabinet screws. Just push it on, they are aligned, but the holes on the charger itself is a little smaller than most other brands.
As for every other brand, just tighten the screws until you can't easily pull the charger off the mount. This is a non-issue for the Ryobi, but all the sliding ones need a tighter fit to stay put.