Polydryer Snapdryer MaxVents Desicant holder V4
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Version 4 of the remix with a narrower toe slot. This is P-I-P without need for support or brim.
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 87
- Wydruki
- 2
- Wyświetlenia
- 278
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The most recent set of boxes I received (4 of them) all have a bit narrower slot to place the “toe” into. I have remixed V3 into this V4 using the values supplied by Macco in his review of V3. I did a test print and they do slide in the slots easier. Thanks to Macco for listing his measurements. The final print (using my caliper) is 1.52 & 1.48 mm at the bottom and 2.47 &2.52 at the top of the wedge. I assume the additional is due to the 45 degree angle used during the print. On the vertical the narrow end was set at 1.30 mm with wedge up to 2.2 mm. These now slide in without force.
Version 4 of the remix with a narrower toe slot. This is P-I-P without need for support or brim, just make sure you have good first layers. Go slow for the first few layers. I used clear PETG to be able to see the desiccant color change and it shows through great.
These are the ones I use in all my boxes and they dry in my A-frame dryer model without needing to remove the desiccant making a mess.