Denver Broncos logo no MMU needed
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
print the colors separate and then glue or snap together
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 37
- Wydruki
- 0
- Wyświetlenia
- 94
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- 2D Plates & Logos
- Licencja
- Creative Commons — Public Domain
Denver Broncos logo that you can print the colors separately. You don't need a MMU. Print the colors separately. I made it so everything is the same height. I you want white and orange to be taller then just scale them thicker. I will warn you that anything less than about 10" from mane to nose and the eye will be very small and difficult to put in place. I rotated the model in the y direction 180 degrees so it prints the face on the bed. I used a textured sheet because I like the effect. If you do that the blue will need to have supports and a support blocker( I used a 4mm cylinder shape in Prusa slicer) around the eye so the filament does not melt around the eye and make the support impossible to remove.