Gaggimate Pro External Backpack Mount for Gaggia Classic Pro
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An external mount for a Gaggimate Pro on a Gaggia Classic Pro
- Ocena
- 5 / 5
- Polubienia
- 18
- Pobrania
- 132
- Wydruki
- 1
- Wyświetlenia
- 598
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is an external "backpack" mount for a Gaggimate Pro PCB that mounts to the vent holes via 2x M4 screws for a secure mount.
Feed your wires through the vents, possibly with some wire loom or wrap to prevent any chafing.
Extras Needed:
All Versions:
2x M4x8 bolts and washers to attach the base. Possibly nylon to prevent any damage to the painted surfaces of the Gaggia.
Several pieces of wire loom or grommets or rubber tube to prevent chafing on the metal vents
Would recommend one piece or grommet for the HV wires, and other pieces for the LV wires.
See photos for examples of small grommets being used.
Version 1.0:
2x M4 nuts to attach the base.
Version 1.1
2x M3x4 bolts to mount PCB.
Version 1.2
2x M3x4 bolts to mount PCB.
2x M4x20-30mm coupler
2x M4x16 bolts (If you use a 30mm coupler could get away with 6mm bolts)
Versions:
Base:
V1.2 Base: Has M3 screw holes like 1.1, however adjusted for clearance for SW2 Micro switch on the PCB.
V1.1 Base: Has M3 screw holes to hold the PCB for a more secure mounting.
V1.0 Base: Has plastic posts like the original gaggimate base to hold the PCB.
Top:
V1.2: Has holes for affixing the top onto M4 couplers to prevent unintended access to the HV wiring, thanks to the great idea from Khord
V1.1: Clip on, but with adjusted logo placement.
V1.0: Clip-on top cover
Print Tips:
Print the bottom with supports, both for the USB-C opening, as well as the lip in the corner of the PCB bay that holds the PCB in place. I used close supports, they just pop off cleanly for this model.