1 / 7
Oral-B iO USB-C Travel Case Mod (12V PD, No Proprietary Charger) — zdjęcie 1
1 / 7

Oral-B iO USB-C Travel Case Mod (12V PD, No Proprietary Charger)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Convert Oral-B iO travel case to USB-C (12V) by opening case, soldering a trigger board, and fitting a 3D-printed adapte

Ocena
0 / 5
Polubienia
3
Pobrania
17
Wydruki
0
Wyświetlenia
407
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Bathroom
Licencja
Creative Commons — Attribution — Noncommercial

🔌 Oral-B iO Travel Case USB-C Mod (12V PD)

Convert your Oral-B iO travel case to USB-C charging using a PD trigger board and a small 3D-printed adapter. No more proprietary charger when traveling.


⚠ Disclaimer

This mod requires opening a sealed device and soldering onto the PCB.

The case is not designed to be opened multiple times. Proceed at your own risk.


🧰 What You Need

  • USB-C PD trigger module (set to 12V output)

  • Thin wires

  • Soldering tools

  • Heat gun (or similar)

  • Small flat screwdriver

  • 3D printed adapter (included)


🪛 Instructions

1. Open the Case

(Image 9)

Start from the hinge side and carefully pry open the case using a small flat screwdriver.


2. Remove Internal Assembly

(Image 8)

Take out the internal board and battery housing.

The PCB is lightly secured with melted plastic posts.


3. Free the PCB

(Image 3)

Use a heat gun to gently soften the plastic posts holding the board.

Carefully lift the board out without damaging it.


4. Remove Original Connector

(Image 2)

Unscrew and remove the original charging connector.


5. Prepare Solder Points

(Image 6)

Scratch off the protective coating only where needed to expose copper pads.


6. Solder USB-C Module

(Image 2)

Solder wires from the PCB to the USB-C PD trigger board.

Make sure polarity is correct.

Important: The USB-C module must output 12V (USB-PD trigger required).


7. Install USB-C Adapter

(Image 4)

Insert the USB-C board into the 3D-printed adapter.

This is a tight press-fit—push firmly until fully seated.

You may need to slightly trim the USB-C board to avoid interference with the coil.


8. Mount in Case

(Image 7)

Secure the adapter in place and reassemble the internal components.


9. Close the Case

(Image 1)

Snap everything back together carefully.


🧪 Testing

Test functionality at every step before fully closing the case.

Reopening it is difficult and may damage it.


🖨 Print Settings

  • Material: PLA (Prusament used)

  • Layer height: 0.1 mm

  • Nozzle: 0.4 mm

  • Supports: None


💡 Notes

  • The adapter is designed as a tight friction fit to prevent loosening.

  • Removing it later will likely break the printed part.

  • Works with any USB-C PD charger capable of 12V output.

Tagi