1 / 5
Bookoo Themis Ultra Tray for Rancilio Silvia — zdjęcie 1
1 / 5

Bookoo Themis Ultra Tray for Rancilio Silvia

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A new drip tray to locate your Bookoo Themis Ultra bluetooth scales on your Rancilio Silvia

Ocena
0 / 5
Polubienia
5
Pobrania
69
Wydruki
0
Wyświetlenia
473
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I suggest using PETG or another somewhat temperature resistant filament. It will see a little hot water and steam. There are some "high temp" PLA filaments around that might also be ok (I've not tried). If you're a careful coffee maker, it might not see a lot of heat.

I print the tray upside town on its top surface. Others have had success printing it on its front face or a side face.

SUPPORTS REQUIRED - If you have a multi-filament printer I suggest using PLA supports for easier removal. I don't yet and unfortunately PETG sticks to itself quite well making support removal difficult... Suggest using support Top Z distance of 0.3mm (1.5 x 0.2mm layer height). I recommend you experiment with support settings using one of the small test models available on Printables before committing to this print. If you have better support experience, then please make recommendations in the comments for others. I'm a relative beginner!

One of the photos marked "FLAT!" shows the rebated surface that locates the base and feet of the Bookoo Themis Ultra scale feet. It is very important this surface is flat and relatively smooth or your Bookoo scales won’t work properly. This will be the supported surface if you follow my propose printing orientation... You can see that my print is far from perfect there but it's still flat enough to work. Pay attention to this surface!

My Bookoo scales seem to be a little sensitive to coffee machine vibration occasionally, especially when the pump first kicks into life. I've tried to mostly isolate the tray from the Silvia pump vibration by adding some soft pads made from 9x4mm weather strip. Similar weather strip appears to be fairly widely available. The tray has rebates on the underside to aid location of the weather strip pads. The printed tray still directly touches the Silvia in two locations at the back corners but it seems ok. Fortunately, those two contact points are aligned to slide in the same direction as the pump oscillation axis. I don't have a problem with pump vibration anymore.

I've noticed the Bookoo scales can also be upset (not tare nicely) if the silicone cover is touching the sides anywhere. The drip tray is designed to locate the scales to mitigate this but sometimes the silicone cover wanders backwards and touches the Silvia's front panel. I've gotten into the habit of pulling the silicone cover forwards with my fingers as shown in one of the photos.

I've also designed a complimentary outlet nozzle for the Silvia's 3-way valve: https://www.printables.com/model/1692756-rancilio-silvia-3_way-outlet-spout

Time for another coffee;)

Edited 5th Aug 2026 - Revised files attached. Fixed a couple of minor issues.

Tagi