Card Holder w/ Magnet Release Lanyard
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
RFID ID Badge Card holder w/ print in place hinged lanyard and magnetic quick disconnect.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 31
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Fashion Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
This badge holder is printed in PETG with supports and finishes in under 2 hours. I needed a removable ID holder for my RFID badge at work—something I could quickly detach for scanning in restricted areas—yet nothing off‑the‑shelf was convenient. So I designed my own hybrid system using a few great community models as a foundation.
The card holder is adapted from this excellent design: https://makerworld.com/en/models/604063-id-key-card-holder#profileId-526683
The lanyard loop is borrowed from this cable strain‑relief model: https://makerworld.com/en/models/1682060-parametric-strain-relief?from=search#profileId-1782057
The clip interface is modified from this AirTag mount: https://makerworld.com/en/models/2372424-universal-airtag-clip-money-belts-bags-gear#profileId-2596585
I added a print‑in‑place hinge at the top of the badge holder and created a pocket for two 15 mm × 2.5 mm round magnets. This gives the holder a quick‑disconnect feature: it can be released easily with one hand, but it resists a straight pull surprisingly well. The flat magnets also let the badge rotate freely while staying centered.
For assembly, I strongly recommend adding a drop of superglue—these magnets pull hard and will rip out if left unbonded.