1 / 8
Magnetic articulated snake puzzle (Rubik’s Snake style) — zdjęcie 1
1 / 8

Magnetic articulated snake puzzle (Rubik’s Snake style)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Magnetic articulated snake puzzle with screw joints; embedded magnets ensure precise, repeatable positioning.

Ocena
0 / 5
Polubienia
3
Pobrania
11
Wydruki
0
Wyświetlenia
169
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

My first model is inspired by classic twisty snake puzzles from the 1980s (such as Rubik’s Snake). This is an original design and is not affiliated with the Rubik’s brand.

Assembly requires:
  • 23× M4 × 12 mm screws (cylindrical head)

  • 23× M4 lock nuts

  • 46× M4 wave washers (outer diameter 9 mm)

  • 192× cylindrical magnets (3 × 2 mm) — yes, really 🙂

Additional requirement:
  • 2× helper magnets (e.g. 6 x 3 mm) per printed Body

Printed parts:
  • 22× Body

  • 1× Body_end1

  • 1× Body_end2

  • 24× Lid

Print settings:

PLA is recommended due to the heated bed temperature. The first row of inserted magnets is separated from the build plate by only one layer, and temperatures above ~80 °C can cause permanent loss of magnet strength.

Recommended slicer settings:
  • Nozzle: 0.4 mm

  • Layer height: 0.15 mm

  • Detect thin walls: OFF

  • External perimeters first: ON

  • Perimeter generator: Classic

  • Pause the print at layers 18, 79, and 159 to insert magnets

Magnet orientation and insertion:
  • 1st row (4 magnets per part): no issues, insert normally.

  • 2nd row (2 magnets): press the magnets firmly into the pockets (a short piece of filament works well).

  • 3rd row (2 magnets): same orientation as the 2nd row. Press the magnets into the pockets and secure them from the outside using a helper magnet. The magnets are repelled by the 2nd row and may pop out during printing if not secured.

Assembly:

Tighten the joint firmly, but not excessively, so that the magnetic detents still function properly.
The lid is snap-fit and does not require glue.

Tagi