Modular Monitor Riser & Desk Shelf /w Modular Drawers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Modular dowel system for monitor riser or desk shelf for 20mm dowels with many possible combinations and modular drawers
- Ocena
- 0 / 5
- Polubienia
- 59
- Pobrania
- 133
- Wydruki
- 0
- Wyświetlenia
- 1535
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I built this system first for my kids to organize pencils, markers, pens, crayons, or basically anything as you can see:
Then I printed it as my work monitor riser:

Modularity:
You can print just the side panels without drawers to use it as a simple monitor riser/shelf.

Alternatively, you can print one side as a shelf unit with only narrow drawers, which is the setup I made for my office.

Another option is to print a shelf unit with two small drawers and one large drawer on one side, and just a simple side panel on the other.

It could be also on the other side:

Or you can have small shelf and big shelf together:

There is many options how to made it. How you decide to combine and configure it is entirely up to you.
Drawer Modularity:
Small drawer
The drawers are designed to be used either as a single open compartment or divided into smaller sections. The small drawer can be divided into up to 4 smaller sections. To divide it, you just need to print a separate divider (as shown in the image), which easily slides into the grooves inside the drawer:

You print as many dividers as you need (max. 3 for 4 separete boxes) or none. Totally up to you.




Big Drawer
The large drawer can also be divided into 4 sections, on 1/2, or you can left it completely open—it is entirely up to you. Just like with the small drawer, the dividers are printed separately and slide directly into the grooves inside the drawer:

Again as with the small drawer, you can combine as you wish. Best is ,dividers are not permanent, you can adjust them anytime you want.



Extra:
I have also included mounts for IKEA desk lamps, which my kids use while drawing. The mounts are designed with a slightly larger hole diameter so that they can be easily moved and slid along the dowels wherever you need them.

Folder Guide (Instructions):
Print first: This folder contains a test model. Use it as a tolerance tester before starting a large print to check how the hole diameter fits your specific dowels. Based on the fit, you can adjust the scale of all the other parts if necessary. The model has a hole diameter of exactly 20.25mm.
Left shelves: Contains shelf units intended for the left side. This means their leftmost side has a blind hole (not through-hole), while the right side has a through-hole. It includes the large shelf, the medium shelf and side panell.
Right shelves: The same concept as above, but for the right-side shelf units.
Middle shelves: Here you will find shelves that have through-holes on both sides and you can use them in the middle of the dowels.
Drawers: Contains the small drawer, large drawer, and their respective dividers.
Others: Contains the lamp mount.
My Print Settings
Material: I use ASA because I have it. PETG could be great too. I mostly dont work with PLA.
Infill: 25%
Walls: 5
Supports: None needed if oriented correctly.
*IMPORTANT DISCLAIMER:
Idea to use dowels is from: youtube.com/@theworkspacehero but I designed this models here by myself. Go check him, he has amazing system.