1 / 4
X-Shot MPP Barrel Shroud (No Logo + No Sling Mount + Gapless + Optional Rail) — zdjęcie 1
1 / 4

X-Shot MPP Barrel Shroud (No Logo + No Sling Mount + Gapless + Optional Rail)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Barrel Shroud for X-Shot MPP dart blaster with optional bolt on rail.

Ocena
0 / 5
Polubienia
7
Pobrania
26
Wydruki
0
Wyświetlenia
380
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a remix of Trailblazers remix of the X-Shot Motorized Piston Pump barrel shroud. I adjusted the design a fair bit, removing the sling mount, separating the rail from the shroud, adjusting scaling on some areas, adding clamping bolts, and making an inbetweener size on request.

The now optional picatinny rail is mounted using standard commonly available hardware:

1 X M4 hex nut for the rear most screws

3-5 M4 X 12mm socket head screws

2-4 M4 MLOK nuts

To clamp the shroud to the barrel collet:

2 X M3x5x4+ brass heat set inserts.

2 X M3 X 40mm socket head screws. Those stick out a little so you could easily go with 35mm length if you use longer inserts or set them deeper.

2 X M3 X 7mm flat washers.

Happy Blasting!

Tagi