Tapo C100 Slim shell with GoPro mount

This is a remix of the original Tapo C100 case, updated to actually fit hardware version 5.0. If you've got v5.0 and the original case gave you trouble, this one's for you. What changed from the original:

The reset button hole is 1mm larger (the original was physically holding the button down for my version) The power plug hole is 2mm larger (the plug wouldn't seat fully and kept falling out) Lid updated to support the newer IR emitter standard Overall tolerances loosened by 250µm for a less snug fit (my printer runs a little tight; your mileage may vary) GoPro mount added

Important heads-up: This is an inverted mount! This is designed specifically for the Tapo C100 hardware version 5.0. I can't make any promises about other versions. Even if you are on v5.0, the daughter board that holds the IR emitters and status LED may differ from mine, so that part is still a bit of a wildcard. Make sure yours looks like mine! picture included at the end

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

Supports:

Resolution:

Infill:

Filament Material:

Category: Other