Tapo C100 Slim shell with GoPro mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a remix of the original Tapo C100 case, updated to actually fit hardware version 5.0. If you've got v5.0 and…
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 7
- Makes
- 0
- Views
- 32
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a remix of the original Tapo C100 case, updated to actually fit hardware version 5.0. If you've got v5.0 and the original case gave you trouble, this one's for you. What changed from the original:
The reset button hole is 1mm larger (the original was physically holding the button down for my version) The power plug hole is 2mm larger (the plug wouldn't seat fully and kept falling out) Lid updated to support the newer IR emitter standard Overall tolerances loosened by 250µm for a less snug fit (my printer runs a little tight; your mileage may vary) GoPro mount added
Important heads-up: This is an inverted mount! This is designed specifically for the Tapo C100 hardware version 5.0. I can't make any promises about other versions. Even if you are on v5.0, the daughter board that holds the IR emitters and status LED may differ from mine, so that part is still a bit of a wildcard. Make sure yours looks like mine! picture included at the end
Print Settings
Printer Brand:
Creality
Printer:
Ender-3 v2
Rafts:
No
Supports:
Doesn't Matter
Resolution:
.12mm
Infill:
45%
Filament Material:
PLA
Category: Other