1 / 4
Wandhalterung für Radschuhe mit SPD Platten/ Wall mount for cycling shoes with SPD cleats — zdjęcie 1
1 / 4

Wandhalterung für Radschuhe mit SPD Platten/ Wall mount for cycling shoes with SPD cleats

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Verstaut eure Radschuhe an der Wand/ Store your cycling shoes on the wall

Ocena
0 / 5
Polubienia
2
Pobrania
10
Wydruki
0
Wyświetlenia
124
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Mit dieser Halterung könnt ihr eure Radschuhe an die Wand hängen. Ich habe darauf geachtet, dass sich die Schuhe einfach einhängen lassen. Die Halterung wird mit 2 Senkkopfschrauben mit einem Durchmesser von 3 mm befestigt. Ich selbst habe vier Stück für zwei Paar Schuhe auf eine Holzleiste geschraubt, die an der Wand befestigt ist. Das schafft auch etwas mehr Abstand zur Wand, sodass diese nicht schmutzig wird.

In die Halterung habe ich einen Neodym-Magneten mit den Maßen D10 x 5 mm (Haftkraft 3,5 kg) mit Sekundenkleber eingeklebt (Position siehe Foto). Der Magnet reicht aus, um den Schuh sicher zu halten. Entfetten nicht vergessen und 24 Stunden warten, bis der Kleber ausgehärtet ist. Beim Druck ist Support erforderlich (siehe Screenshot). Als Infill habe ich 25 % vorgegeben.

Translation: DeepL

With this mount, you can hang your cycling shoes on the wall. I made sure the shoes are easy to hang. The mount is secured with two 3 mm countersunk screws. I screwed four of them onto a wooden strip attached to the wall to hold two pairs of shoes. This also creates a bit more space between the shoes and the wall, so the wall doesn’t get dirty.

I glued a neodymium magnet measuring D10 x 5 mm (holding force 3.5 kg) into the mount using superglue (see photo for position). The magnet is sufficient to hold the shoe securely. Don’t forget to degrease the surface and wait 24 hours for the adhesive to cure. Support is required during printing (see screenshot). I set the infill to 25%.

Tagi