Asus NUC Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A small stand to improve airflow and lift the NUC off the desk slightly
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 109
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial
A simple stand for the ASUS NUC 16 that does two quiet, useful things: it opens up the bottom of the chassis for airflow, and it lifts the whole unit about a centimeter off the desk. That little bit of lift is the part I actually designed this for — my monitor stand sits behind the NUC and its base was just tall enough to kink the cables coming out the back. With the NUC raised, everything clears cleanly.
The top surface is a honeycomb grid rather than solid plastic, so the NUC's intake fan isn't sucking against a dead plate. A low lip around the edge keeps the unit from sliding around. The printed feet work fine on their own, but there's room to add rubber or felt feet underneath if you want extra grip or vibration dampening.
Print notes
Printed mine in PLA, 0.2 mm layer height, 3 perimeters, 20% infill. No issues with heat.
No supports needed; print it upside down.
Designed in FreeCAD. Source file included if you want to tweak the footprint for a different NUC generation or a different SFF PC entirely.