Salad Survivor v02
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is for the supermarket salads that come with a root system. Newly added a taller version for spring onions.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 36
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The most common sizes I've encountered were a bit smaller than 8 cm and 6 cm, cubed. The upper 2 cm of the soily squares are mostly free of roots. It is also important to keep the most outer leaves from any pressure of the container to keep the leaves supplied with water and alive. Thus, I've made it both times 4 cm tall, to leave some air. The ramp on the side is to refill and perhaps check the water levels.
This version has two additional models for spring onions. They have to be taller to support their shape. It's much easier to fill this with water. For that reason you have a model without the nose and overhang.
Happy printing 👋 happy salading 🌿
Print instructions
Print with PETG for water-tightness
Print with 4 perimeters or more
No support
I've used 0.2 mm layer height with a 0.4 mm nozzle
Sizes
Version with 8 cm x 8 cm and 4 cm tall.
Version with 6 cm x 6 cm and 4 cm tall.
Version with 7 cm x 7 cm and 8 cm tall.
Version with 7 cm x 7 cm and 8 cm tall and without watering nose. It's anyway easy to water spring onions.
License
You must give appropriate credit
If you remix you must distribute under the same license: Creative Commons — Attribution — Share Alike