Wine cork cutter jig
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wine cork cutter jig
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 278
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
Wine cork cutting jig. A wine cork alignment tool for making straight and smooth cuts using construction knives with flat 18/25mm wide by 0.5mm thin blades. Cutting cork length approx. 3-45mm. Cork diameter up to 25mm. PETG is highly recommended. Place parts on printing plate as they are oriented. Supports are recommended for tapped hole on the main body only. The screw is printed without any supports. See section diagram attached for assembly.
Insert red WallPart1 into white Body from the tapped hole end so it match side guides
Insert Screw into the tapped hole and screw it in so that it would slide WallPart1 on 2-3cm
Insert WallPart2 (green) into WallPart1 to connect the screw with WallPart1 in it's place
Rotate the Screw to slide moving part back and forth several times for fitting-in and smoth movement
To disassemble the tool screw out the Screw so the WallPart2 could be pushed out off the WallPart1 using bottom hole
It's recommended to use some silicon based grease for Screw smooth rotation.