Studio Series 86 Perceptor back filler
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A back filler piece to suit Studio Series 86 Perceptor.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 42
- Wydruki
- 0
- Wyświetlenia
- 273
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Action Figures & Statues
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A back filler piece to suit Studio Series 86 Perceptor. Part A can be used on its own with manual removal and installation, while Part B can be fit internally to mount Part A to the figure.
Installation of Part B may require backing off the three screws which hold the torso together, and will clamp firmly in place using the internal ledges within the figure.
A small notch is present on Part B to help fit the two pieces together.
If you're feeling really keen a small pin may be used to hold the pieces together, instead of the printed cones. I would not recommend going much, if any larger than 1.5mm or 1/16". Tiny indents are present on the outsides of Part A to help guide a drill.
Part B requires supports to print successfully.
Both parts are designed with very small clearances. Depending upon your printer and configuration you may need to sand or file some edges to get a good fit.
NB Do not turn the head around when transforming with Part B fitted. There simply isn't enough clearance for the head crest. The entire face is covered by Part A anyway so it really isn't necessary.