Studio Series 86 Perceptor back filler
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A back filler piece to suit Studio Series 86 Perceptor.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 41
- Makes
- 0
- Views
- 270
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Action Figures & Statues
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A back filler piece to suit Studio Series 86 Perceptor. Part A can be used on its own with manual removal and installation, while Part B can be fit internally to mount Part A to the figure.
Installation of Part B may require backing off the three screws which hold the torso together, and will clamp firmly in place using the internal ledges within the figure.
A small notch is present on Part B to help fit the two pieces together.
If you're feeling really keen a small pin may be used to hold the pieces together, instead of the printed cones. I would not recommend going much, if any larger than 1.5mm or 1/16". Tiny indents are present on the outsides of Part A to help guide a drill.
Part B requires supports to print successfully.
Both parts are designed with very small clearances. Depending upon your printer and configuration you may need to sand or file some edges to get a good fit.
NB Do not turn the head around when transforming with Part B fitted. There simply isn't enough clearance for the head crest. The entire face is covered by Part A anyway so it really isn't necessary.