Yoshi Trophy with custom supports
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
It took a couple tries to get the angled foot to print properly.The supported Yoshi is about 90mm tall.I printed it at…
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 94
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution
It took a couple tries to get the angled foot to print properly.
The supported Yoshi is about 90mm tall.
I printed it at 0.2Layers, 10% infill, and a 4 wall thickness .
I will probably bump the infill a bit on the next print.
This model was converted from here: http://www.models-resource.com/gamecube/ssbm/model/5337/
EDIT: 08/15/19 - Ran both files through Meshlab and Netfabb Basic. There were four small holes, but nothing breaking it up into multiple parts.
Category: Toy & Game Accessories