Flos inspired pendulum lamp
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Hanging lamp with square and circle shapes intertwined, inspired by Flos Arrangements.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 61
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution — Noncommercial
Requirements:
all files need to be printed, the inner files in black, the outher ones in white PLA
flexible LED stripes which can be cut and soldered together
thin wire (length depending on how high it needs to hang) for the LED stripe and to hang the lamp (the lamp is hanging on the electrical wire)
plug or USB port to power the LED stripe (ideally dimmable)
Instructions:
Print in PLA black: circle inside, square inside, circle connector & square connector and hanger (higher infill, ca. 25% is sufficient)
Print in PLA white: circle outside, square outside (low infill to let the light shine through, I did 15%)
Cut the flexible LED strip to the inner square & circle size, there is a grove to fit it (8mm width with some space to squeeze)
Solder wires to the LED strip, then attach it to the inner side of the square / circle, there are channels for the wire within all parts, especially the connectors
You have to guide and solder the wire from the circle part via the connector to the square part and then guide a wire from the top of the square, via the hanger to your ceiling
The outer parts for the square and circle can simply be slid over the inner parts, if you want you can add a drop of glue so they don't move
I recommend dry-fitting everything before to understand where the wires need to run, then cutting the LED stripes and wires to length, trying to fit it again and then soldering / glueing.