WaterSnake ASP Trolling Motor kayak mount improvements - no supports

I created these accessories to make using my Watersnake ASP 18lb trolling motor a bit easier on the water, and address some issues I found installing on my Pelican kayak. The motor and mount are a great value, and instead of using PVC pipe and silicone like suggested on some Youtube reviews, I designed these mounts one weekend so it has less of that "home depot" look. 

PETG works great for all of these. If your printer is tuned right, each one should be an easy print at .2 layer height and be a snug friction fit with no supports needed. I use 3 walls and 20% hex infill for the wrench and the grips, and the nut cups should be a single wall. 

Knob Grips: Gives a bit more surface to grip your mount knobs for adjustment or deployment when using the ASP. The factory star screws are hard to adjust, these give a bit of extra surface area to easily tighten without over doing it.  Holds with a friction fit for ease of removal, add some silicone inside the middle of the gap for a more permanent solution. Print 2 of these for upper fasteners.

Nut Cups: Print one of these each for the nuts on the other side of the star fasteners (4 total). Keeps the nut contained in the mount, and allows you to tighten the mount firmly without damaging the socket. 

Star Wrench: Used to snug the lower mount fasteners that let the motor mount assembly rotate. Has a hole in the handle for a bit of paracord to keep it in the boat or your tackle box.

Personal use only please. If you would like to make or stock these in your physical or online store, reach out and we can work something out that benefits us all.