Qidi Q2 40mm to 120mm Fan Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
120mm fan adapter for Qidi Q2. Quiet mainboard cooling. Works as-is, but includes optional Klipper config for best resul
- Ocena
- 5 / 5
- Polubienia
- 19
- Pobrania
- 51
- Wydruki
- 1
- Wyświetlenia
- 378
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
Quiet, high-performance cooling for your Qidi Q2 electronics
This direct-fit adapter replaces the small, noisy stock 40 mm mainboard fan with a standard 120 mm fan.
Credits & Inspiration
This project was inspired by the 80mm fan mod for the Qidi Q2 found on the Qidi Russia Wiki.
Since I had a 120mm fan on hand, I decided to adapt the idea for this larger size. It turned out to be a great upgrade, providing even better airflow and near-silent operation compared to smaller fans.
Improved Cooling: Significantly lowers the temperature of stepper drivers and the MCU.
Low Noise: Delivers higher airflow at much lower RPM and noise levels.
Easy Installation: Uses the original 40 mm mounting holes on the electronics bay wall.
Compatibility: Designed specifically for the Qidi Q2.
Recommended Print Settings:
Nozzle: 0.4mm
Layer Height: 0.3mm (works great for this functional part)
Material: PETG, ABS, or ASA (recommended for heat resistance inside the enclosure)
Infill: 20%.
Supports: Not required
Assembly Instructions:
Attach the adapter using the original 40 mm mounting holes on the back wall.
The three cylinders should face the wall.Mount the 120 mm fan on top of the adapter using the four standoffs.
Secure the fan with M3 screws.
Firmware Configuration (Optional): This mount works without any firmware changes. However, for optimal noise and cooling performance, you can update your printer.cfg with the following:
[controller_fan board_fan]
pin: PA9
max_power: 1.0
shutdown_speed: 1.0
stepper: stepper_x, stepper_y, stepper_z, stepper_z1
fan_speed: 0.8
idle_speed: 0.3What this configuration does:
Targeted Cooling: By adding
stepper_xandstepper_y, the fan responds to the most heavily loaded drivers. In the stock Qidi configuration, it often reacts only to the Z-axis, which typically remains cool, while X/Y drivers may overheat during high-speed prints.Balanced Performance:
fan_speed: 0.8provides strong airflow with a 120 mm fan while remaining significantly quieter than running at full power.Quiet Idle: When the motors are inactive, the fan automatically drops to
idle_speed: 0.3(30% power) after a timeout, keeping noise low while still providing light cooling.Safety:
shutdown_speed: 1.0ensures that in case of a Klipper error, the fan ramps up to 100% to prevent heat buildup.
