Adapter for Tomlov TM-DM9 Microscope & iFixes iL37 Polarized Ring Light
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An adapter for Tomlov TM-DM9 Microscope and iFixes iL37 Polarized Ring Light
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 171
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Introduction
This is an adapter for:
Tomlov TM-DM9 Microscope
iFixes iL37 Polarized Ring Light
 Tomlov TM-DM9 Microscope |  iFixes iL37 Polarized Ring Light |
|---|
Here are some of the key measurements, if you have different devices but think this adapter might fit.
Printing
Print in the given orientation. Use "Sharpest Corner" for Z seam alignment. so the seam lands on the given groove on the back of the model.
Installation
Pull down on the original transparent LED hood to remove it from the microscope.
Lay down the ring light with the polarizer inside. Back out all 3 screws until the adapter could be dropped inside.
Drop the printer adapter inside the ring light. Tighten the 3 screws to lock it in place in the center.
Press fit the assembly into the microscope.