Remixed Drybox for Wildone Food Storage Container 4L
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I really liked the Filament Drybox for Wildone Food Storage Container 4L but wanted to change the thickness of the…
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 29
- Wydruki
- 0
- Wyświetlenia
- 573
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
I really liked the Filament Drybox for Wildone Food Storage Container 4L but wanted to change the thickness of the sides. The directions state that I can do 2 x TUSH-3mm Wall and 2x TUSH-1mm Wall. I tried the 1mm wall and found it was a little too flexible. I decided to just add a 2mm wall so I could just print 4. I will also be working on reducing the filament needed in a future iteration.
Instructions:
- 4 x TUSH-2mm Wall
- 1 x TUSH-StabilzerRod
- 1 x WildoneDryboxPlatform
- 2 x TUSH-Brace
Use nuts and screws to hold the brace in place. I found that placing the bearings could be a little tight so I hit the walls with a hairdryer to make it easier to place them.
BOM:
- 4 x 608-2RS Ball Bearings
- 2x M3*8 Machine Screws
- 2x M3 nuts
- 1 x WildOne Food Storage Containers
Print Settings
Printer Brand:
Creality
Printer:
Ender 5
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.24
Infill:
15%
Filament: eSun PLA+ White
Notes:
I did not use support. I think the resolution could probably be bumped up to .28-.32 and the infill set to 10%.
Category: 3D Printer Accessories