ArmoredTurtle Tray with PN532 RFID mount and ESP32 WROOM board
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
ArmoredTurtle tray to support RFID module PN532 and mount for ESP32 WROOM.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 303
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
ArmoredTurtle tray to support RFID module PN532 and mount for ESP32 WROOM. The build is designed for single printed part, minimal support, cable management and avoid overheat of the development board.
Printing recommendation
PLA reinforced as eSUN ST https://www.esun3d.com/epla-st-product/
Wall Loop 2 - Top 4 - Botton 3 - 15% infill with TPMS-D 15% infill density
Support enable only from build plate for the front/back and RFID support (tree recommended)
What do you need per line
HiLetgo PN532 NFC NXP RFID
HiLetgo ESP-WROOM-32 ESP32 ESP-32S Development Board 2.4GHz Dual-Mode WiFi + Bluetooth Dual Cores Microcontroller Processor Integrated with Antenna RF AMP Filter AP STA for Arduino IDE
USB C to Micro B Cable Type C to Micro B Connector 0.5 m
BHCS M3x6 4 pieces
USB C Fast Charger Station
Soldering, straps, ...
This is a final draft I installed on my Voron 2.4 using the following community project https://spoolsense.org/